JB
> @JayBee-git > I can assure you that this is not a firmware issue. If it did, it would be a long time since 100% of users reported it. >...
I compiled your latest source with your bltouch 3x3 template config file, did a full reset, full recalibration, full bltouch mesh (with preheated bed and hotend), tested print with either...
> @JayBee-git > Sorry to insist but if M420 S1 is not taken into account, it means that the mesh is invalid. Either it has not been saved or it...
I already did all those calibrations as well. I am not an expert, but I am not a beginner either here ;) Grip on the bed has no issue, and...
> @JayBee-git > In the firmware, the auto bed Leveling is carried out via the call to Gcode G29 (in bilinear mode) .. this Gcode is coded by Marlin, and...
> @JayBee-git also interested. I seem to be having the same issue. Trying to track down the cause. Like you I have tested with and without G29 and there is...
I was wondering, could we simply use a MCU to connect the sensor to klipper, like we can do with the ADXL345 sensor (for resonance compensation)? Would it solve the...
@ashbuilds true, I know serial can be used in klipper but that would probably require to change some code. BLtouch is going through the printer motherboard which is a MCU...
A real NSO controller, connected to the 8BitMods blueretro adapter.
I also updated the controller just in case, and tested on the official NSO service, rumble works normally there. When pushing the mode button, I also get the rumble pulses...