Hans007a
Hans007a
Anything is wrong with the last revision. My CoreXY printer (Due+ramps_fd v1) drops X-Y steps at different points. I posted my setting many times and I hope You have those,...
Hello, first, thank You for the solving the other bugs :) But after update to the newer versions my SDCard slot stopped to work... I flashed my early backuped version...
Hello, I found a bug in the last release. Anything is wrong with the manual move the extruders from the LCD display. When I go to the move menu and...
LCD reprap full graphics 128x64 don't starts after power up and I have to press reset. after that it starts. I set #define DOGM_SPI_DELAY_US 12 maybe its too much or...
Hello, I will use LoadSDBank with variables for long data files and got an error 9009. Here my code (maybe not perfect, but I can't test it): ``` LoadBigSDBank("xxx.nxt", 95488,...
Hello, The sprite table shows for 4bit sprites only 64 cells, but there should be 128. Download sprites save all 16k, but only the first 8k have data. Upload sprites...
Hello, maybe You can add a feature to the tilemap, that copy a area of a map and paste it to an other location in the same map. This will...
During bed leveling sometimes get my BLTouch an error (blinking red) but after that move to the next point, do reset and continue the bed leveling. It will be better,...
G26 starts to heat the bed and froze the LCD. Nothing works, but the bed is heated to ~70°C (set is 60°C) I have to reset the controller...