HANloading

Sorry for another question. How should I get the form of the anchor chain load if I run it successfully? , such as 6x6 mooring line restoring matrix？？ 

Dear @jjonkman Thank you for your reply. [1]Definition of the Semisubmersible Floating System for Phase II of OC4 By "hydrostatic recovery" matrix, I meant a 6x6 hydrostatic recovery matrix, which...

Dear @jjonkman Thanks for your answer. In order to balance the weight and buoyancy of the whole system (nacelle, blades, tower, platform) and the pre-tensioning of the mooring system, how...

> Dear @HANloading, > > I'm not following how you get 88030 kg, even though I agree with your component masses. Note that the combined hub + 3 blade mass...

Dear @jjonkman [1]Definition of the Semisubmersible Floating System for Phase II of OC4 Forgive me if I don't quite understand what you're saying. 1. isn't buoyancy already taken into account...

Also, after I output the axial and tangential forces per unit length of each blade in openfast (B1N1Fn, B1N2Fn,B1N3Fn) to derive the data like inside the brackets, what if I...

> When I model a wind turbine with 14 degrees of freedom, is it not also necessary to consider the additional damping and additional stiffness of the platform (generated by...

Dear @jjonkman Is the SeaState.dat file available for IEA15MW? If so how should I proceed to use it?

Dear @jjonkman So, please, is there any introduction to the internal calculations of potential flow theory? I'm trying to figure out what input parameters are related to the potential flow...

Dear @jjonkman I'm sorry, but I'm not sure what parameters PRP Body Kinematics, WAMIT Body Kinematics, WAMIT Body Forces in Hydrodyn in the outlistparameters correspond to in the potential flow...