GoTVm

First off, for some reason the link did not appear in my original comment. I'm still getting used to GitHub, apologies. When I talked about web scraping, I thought about...

This has been happening to me since I installed it around 6 months ago exactly like @vertigo220 described in the OP. The application gets stuck and the only way to...

Any hint about what driver is causing this?

Mine was "fixed" in one of the updates; it freezes a lot less than it used to but still does sometimes ________________________________ From: Momtchil Momtchev ***@***.***> Sent: Sunday, June 23,...

Thanks for the quick answer, I figured out how the redraw variable worked and managed to automatically clear itself every time the loop resets. The current **working** prototype code is...

What do collision homing and collision calibrate do? I disabled them because the tutorial I was following didn't use them and because they are not very clearly documented Sent from...

So basically I can either: - move the nozzle close to the bed by hand and then calibrate - activate collision sensing and then just auto homing correct? About collision...

Okay I will follow the video and update the post Sent from Outlook for Android ________________________________ From: Mark ***@***.***> Sent: Tuesday, December 3, 2024 9:15:42 AM To: markniu/Bed_Distance_sensor ***@***.***> Cc:...

I activated collision sensing but now it says triggered in air, 748 and the z axis keeps moving up until it says move out of range 115 115 -0.1 Sent...

Managed to get the calibration done without collision sensing, now it reads always 0.1mm higher