Gabriel dos Santos

How to connect a W5500 shield on esp32 to run the example

1

I'm using an esp32 with an etherner shield W5500, do you think it's possible to make it work? because I couldn't find any place to configure the module pins

I found an "ERROR" in your library with the software I'm using.

3

I found an "ERROR" in your library with the software I'm using, could I change the channels that are sent? change the start channel and end channel of the universe?

hello everyone, I have 8 panels, 32 columns and 16 lines, connects 4 lines of 2 panels, connected exactly as in the photo below, but I cannot map to leave...