Florian

I've a similar desk (E1S) and want to see it in this project as well. The control panel optically looks exactly the same but is HCB103A-2. Board has the silkscreen:...

Well, I created a adapter to breakout the RJ45 to 2.54mm THT Headers and checked the signals with my oscilloscope. I haven't seen usefull signals on the pins. All tested...

Would at least be easier/cleaner on yours, as they use a FPC-cable in my version now:  

After checking again [HS01B-1](https://github.com/iMicknl/LoctekMotion_IoT#hs01b-1) could fit. GND [7] is at the right place and 5V [8] (5.7V actally from a internal 3.5A DC-DC converter) as well. Pin 6 can be...

Sadly there is no output on the potential RX and TX pins. (Tried with two serial adapters at my PC via hterm) - WakeUp command (0x9b 06 02 00 00...

Had the same issue recently. Part within config.ini was missing as well. Probably I started deCONZ as sudo once, as the config.ini had rights for root:root. Changed it via chown...

The Pinout of this dongle just proves [HS01B-1](https://github.com/iMicknl/LoctekMotion_IoT#hs01b-1). It shows a permanent connection between Pin8 and Pin4. **Bluteooth-Dongle Pinout** 1 - 2 - 3 (white) SWS 4 (red) 5V-SW ->...

Hi guys, I just had this project in mind again and tried the new ESPHome method, but it did not work as well. So I gave up using the serial...

Maybe there is a fuse-Bit Problem or something like this. To specify the Issue: If I'm connecting the Motor with a flashed ESC and let it free-wheeled at lowest throttel,...

When I take a look at your pictures, I have the Problems, with the "old" version.