FabioM3
FabioM3
There are a few extensions that shows the dislikes count in chrome store.
I think you don't have to select a COM port. And arduino ide 1.85+ don't work with hid-bootloader. But you have a lower version.
However, you can also connect two accelerometers simultaneously, though they must be connected to different boards (say, to an RPi and printer MCU board), or to two different physical SPI...
Use the types that exist in recognizeType.cpp, like uint16_t.
You have activated the io pins? Look at the tutorial of installation of this board.
Now it makes sense, in prusa slicer there's the same problem, if you change the extrusion multiplier the max flow rate is not respected.
The problem is sorted out in the orca slicer(but not fixed yet), the problem occurs because the math relies on an fixed extrusion multiplier of 1.0. If you change it...