FHOGPHIL

Results 8 comments of FHOGPHIL

MCU 'ercf' shutdown: Timer too close

> yes

MCU 'ercf' shutdown: Timer too close

Seems similar to #68

MCU 'ercf' shutdown: Timer too close

at least 4 times now and each time on an unload to switch tools mid print

MCU 'ercf' shutdown: Timer too close

Thought it might be a camera issue so pulled camera. didnt help, On the unload command, the filament got out of the extruder and when the high speed unload started,...

MCU 'ercf' shutdown: Timer too close

RPi 4B 2GB/SSD EZBRD and SSD on USB3.0

MCU 'ercf' shutdown: Timer too close

So I found a solution. every time the command "{% set ercf_params = printer.save_variables.variables %}" comes up I added a line after it that reads "G4 P500". (Obviously there are...

Pause command causing "Move out of range:" issue

Are you using the pause and resume macros specifically for ERCF?

Pause command causing "Move out of range:" issue

> > Are you using the pause and resume macros specifically for ERCF? > > Yes... I run the "pause" command from the Octoprint terminal. That’s not what I asked....