EnteSuesssauer15

i setup home assistant a few days and had no issues with the sensors. today i reinstalled everything and now its gone and dont know how to get it back...

need help with setting up gpio in octoprint docker

1

My octoprint install is running inside a docker container and recently I've built a relay into my psu to switch it on and off but when typing kn the correct...

Where does it go?

Health check fails

3

tried putting my domain there the ipv4 localhost 127.0.0.1, nothing works ``` Status | starting Failure count | 0 Last output | % Total % Received % Xferd Average Speed...

System.write(SYSTEM_WAKE_UP); applies to every buttonpress

4

i have 6 buttons connected to my pro micro and on button 6 i have placed this to be able to turn on my pc. System.write(SYSTEM_WAKE_UP); after a few days...

im might be too stupid to enter the api key

2

i installed the app as usual and wanted to enter the api key but nothing happens, it always says that i need to click to get an api key but...

Plans for TS6?

3

It may be a little early to ask this, but will TS6 be supported in the near future, or will this project be abandoned?