Karsten

Can the SmartEVSE V3 be made to read the Modbus TCP from a meter over WiFi? I'm thinking of connecting the EVSE to a Sunny Homemanager 2.0 to charge excess...

Info: In Germany, a continuity measurement of the protective conductor with at least 200 mA must be carried out, otherwise the measurement is considered not to have been carried out....

A residual current circuit breaker of 30mA may trigger from 15mA and must have triggered up to 30mA. A measurement with a current of 200mA is therefore not possible and...

I solved this for myself with ioBroker (like Homeassistens, NodeRed,...). He knows when the electricity tariff is cheap. Normally the SmartEVSE is in solar mode, when the price is below...

Your energy supplier will only impose the Relias (NC) on you if your wallbox is registered this year and the power connection is in Germany. In addition, he must have...

The technical requirements from the energy supplier are quite simple: currently only potential-free contacts are provided. Some do this as part of the SmartMeterGateway, others produce these ripple control receivers...

It would be a possibility, not elegant since HomeAssistant and the WLAN are there in between, but feasible. I would then have to send an API to the SmartEVSE every...

I'm in Smart mode and then enter the value 80 in mqtt.0.SmartEVSE.ChargeCurrentOverride. After a few seconds the value is written back to 60 I can do everything on the web...

Yupp, I'm German and do English via Google. Everything works well via the web interface, I can set all the restrictions there. Limiting to 6A also works in the API:...

> A more fitting technical solution would be to have a separate input-device (like the sensorbox) that is connected through modbus to the SmartEVSE. This device could then read in...