Prithvi Raj Narendra
Prithvi Raj Narendra
Hello, thanks for this open source project. Would you be providing the .kicad_pcb files for the layout as they are missing you? Regards, Prithvi
The targets of flash, flash_softdevice and erase work based on what the variable DEBUGGER is set as: JLINK or BMP. Needs `arm-none-eabi-gdb` in the path for BMP to work.
Hello @bnahill and co developers Thanks for this tool. I came across it in this [Interrupt](https://interrupt.memfault.com/blog/advanced-gdb#svd-files-and-peripheral-registers) blog. So I cloned the repo, installed it with python3 with setup.py. Then in...
For all the decoupling caps in the project, it would be good to have one or two via to GND in layer 2 to have low inductance from capacitor GND...
Considering we can use 16s NMC cells too, it would be better to get the 64V or next higher Reverse Stand off Voltage Vr rated SMC TVS diode in bms-power-100a...
https://www.planetanalog.com/a-primer-on-battery-management-system-bms-for-evs/ This article talks about 0406 resistors instead of 1206 resistors for balancing heat dissipation. Just FYI.
Some options are - Rohm's [BD9G341](https://octopart.com/search?q=BD9G341¤cy=USD&specs=0) or [BD9G500](https://octopart.com/search?q=BD9G500¤cy=USD&specs=0) - [MIC28512](https://www.mouser.in/c/?q=mic28512) available in Mouser. 2A output capability may not be enough if you want to support power for driving contactors and...
### Answers checklist. - [x] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there. - [x] I have updated my IDF branch (master or...
### Answers checklist. - [x] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there. - [x] I have updated my IDF branch (master or...