DerSpatz
DerSpatz
While I am pretty good at designing electronics, my programming skills are next to none. I know enough about how software works to design my hardware in way way that...
Hi @toblum , Danke! Grüße, Bastian
Hey Makuna, thank you for your effort! The INK1101 does not have a special color order as it is just a LED driver IC. The color order comes from the...
Sorry if I caused some confusion... From my understanding, the usual "inverted" methods invert the signal between uC (like Arduino or ESP32) and the LED controller IC (as in the...
> And you are using these to increase the voltage and amperage support of your LEDs. I thought there were chips (like a WS2818) already out there that did that...
Done! https://github.com/Aircoookie/WLED-Docs/pull/93 I could fix the issue on my prototype board by lowering the resistor divider values to 500 Ohms and 1kOhms. As I already wanted some "cosmetic" changes on...
Looks great! Thank you!
@TKaluza The MIDI board is connected via UART, so using a ESP32-H2-WROOM module instead of the MIDI board should be possible, if you want ZigBee. Design is mostly done, but...
@florianL21 Sounds good, let's get in contact! Ich schicke dir nächste Woche mal ne Nachricht, bin übers Wochenende unterwegs...
Not yet, sorry. This is not ready for full release yet...