DFliyerz
DFliyerz
Unfortunately this doesn't seem to fix the issue, as two animations being run at the same time that each set the same blendshape to 100 will result in the blendshape...
This printer was freshly assembled, and the only lubrication was from what the bearings came with. How should I go about lubricating it? I have 3-in-1 oil as well as...
I lubricated the linear rods as described, and it still crashed while printing the benchy.
They are, and I'm not exactly sure how I could describe moving the bed. It's not easy, but it's not really hard?
I'll check the tightness of the bearings
I re-did the bearing tightening, but it crashed again on the benchy. I wonder if there's just a way to turn down the crash detection sensitivity, so it doesn't keep...
It does, and I can print fine with the crash detection turned off. Btw this is with the files that are supplied with the printer, so I'd expect them to...