Cose-3D

Very nice Just it doesn't work with symbols above code point 10175 This is the font I used for testing https://fonts.google.com/noto/specimen/Noto+Emoji

> @edo44 can you share which command did you use to generate the font and the code to display it? Would be easier to test what might be the problem...

> > > @edo44 can you share which command did you use to generate the font and the code to display it? Would be easier to test what might be...

> I enabled utf8 in my library, yep. By the way I now understand why emoji can't be shown, the utf decoder it's 8-16 bit while emoji are stored in...

> That is absolutely not possible, as both of Tonex pedals does not have BT. In some setups I am using Airstep controller with WIDI device connected to Tonex (or...

> I don't have the bigger Tonex to check anything, but it sounds like it doesn't have Midi over USB.  Are we sure?

You can't use more than one controller with deej but you can make a 2 piece box for your controller with a small printer instead of printing a single big...

> This is what I am using for EndeavourOS Plasma KDE > > https://github.com/czanescu/deej-with-libayatana-compatibility > > I didn't need to install any of the prerequisites, but as of some linux...

> My devices is on ttyACM0. It shows the device path as `/devices/pci0000:00/0000:00:01.2/0000:02:00.0/0000:03:08.0/0000:07:00.3/usb3/3-3/3-3.3/3-3.3:1.0/tty/ttyACM0` > > I am unable to find the exact file I need to change. > > That...

I have the same skipping steps problem but with common 10K linear pots. Also due to the fact my code sends xxxx | yyyy | zzzz values only when it...