Badn1nja
Badn1nja
Cold you be short and hot long
Please use a YAML validator that will tell you what is wrong about your config file
yaml.scanner.ScannerError: mapping values are not allowed here in "config.yml", line 34, column 20 is the problem though from the logs - check what is on that line in config.yml
Hello, I have started to use this plugin and have this issue as well. I have monitored the issue and I believe the issue lies with the "Connect to Octoprint...
> I can work around by waiting for the usbserial to show in octoprint then connecting manually but maybe a customizable delay to the connection back to the printer could...
I set the post delay to 10 and this was perfect for my ender 5 Pro. I can have thr printer now idle and power and print automatically via cura
Yes I am using an esp8266 running wled on the pi so if the connect is run too early octopi fails as it cannot connect to that and deems nothing...
> I created a new issues about this problem, someone have found some fix ? Can you increase the delay? The info should be above
You can wire into the GPIO pins that are found here; https://www.raspberrypi.org/documentation/usage/gpio/  In order to select the pins for the PSU Control that can be done as below; Here...
Hi Beppe, It looks like Prusa might be slower to initiate, can you try a 60 or 120 second delay to see? Is the printer on AMC0?