Václav 'ax' Hůla
Václav 'ax' Hůla
Yes, you have to make them virtual, but you have to do it in Wire.h. Having this merged is just a step on my quest to get it working upstream...
I have more concrete use-case for this request: I want to use more i2c devices with same hard coded address (in my case more than two of adaftruit's BME280). Adafruit's...
When we replaced the fetch task with fresh one, it did not receive new messages (there were messages in assigned partition) and got finished too, without logging anything. I see...
Please rename the file to Prusa3ALU-SolidBed.dxf and push the change to your fork, it will get propagated there. This is certainly not going to be merged before the filename change.
Turn the carriage upside down and all should be ok.
rod lengths depend on your wanted print area and frame size, there are instructions how to calculate them: https://github.com/josefprusa/Prusa3/blob/master/box_frame/doc/dimensions.md
x-carriage is already updated to lm8uu, reducing springiness is on the way.
vlnofka is working on extruder
Lodran: Yes, carriage has issues with belt atm. Thinking about it.
The problem is that by change in configuration.scad can result in chabge in bom - change to bushing*, idler_bearing or i_am_box results in different BOM. I am not sure if...