ArnoTlse

Hi, I have similar issue with H743 board (Lumenier H7 lux) with 4.0.0 firmware installed (quite fresh, I have just calibrated Gyro and configure basic stuff on ports and receiver...

Hi again, I have tested another SD card. In fact the same like the previous except in 16go size. It works fine. Nothing change aside that. Arno

> Is it me or is there no button to save the waypoint altitude and speed anymore? Iirc there used to be a button for this, but now I can...

> Okay, that makes sense, but can you also make the changes to the WP altitude and speed save automatically? It doesn't say anywhere that hitting return saves the WP,...

> Just had a play with the new Mission Control which is looking great. A few things I noted in the latest version were : > > 1. It's possible...

hi @breadoven , On the third point you mention on Map not focusing, I'm not able to reproduce it. When I load a new file, the Map focuses automatically to...

Ok, I have found the issue for EPROM map focus. I have corrected it. I will push it with the other things (filename display, WP speed & Alt on the...

Hi @breadoven , on the [iNavFlight/inav#6662 ](https://github.com/iNavFlight/inav/pull/6662) topic, just to be sure, the P3 parameter to be set for indicating reference from Take-off level or Sea-level is only intended to...

I have added the P3 interface for Altitude reference like that : 

> Correct Arno, the absolute datum is just for geospatial WPs, so Waypoint, Land & PositionHold, i.e. those with an altitude setting. (I assume you meant geospatial rather than Non...