Aaron Yap

unable to run fuseSOC in windows installation

3

Hello everyone, I was attempting to install fuseSOC in my windows 11. The download and installation went well until I ran the "fusesoc --version" command. It says that ... >...

How to interpret the output signals from the VCD file in GTKWave after simulating the IBEX core

1

HI, after succesfully compiling the `hello_test`, running the simulator and opened the VCD file in GTKwave, I am trying to understand which are the output signals but I couldnt understand...

Is it possible to use newer versions of Verilator and FuseSOC

9

The version suggested in this repository is 4.104. Is it possible to use version 4.210, or even 5.107? Or should I install 2 versions of verilator? The reason is because...

Error building GCC for RISC-V

1

I have follow the instructions by [lowrisc](https://lowrisc.org/docs/tagged-memory-v0.1/setup/) step by step starting from "downloading the lowRISC chip repository" section..and yet i have encountered this error.. ``` rrm cpp.pod gcc.pod fsf-funding.pod gfdl.pod...

Installing the toolchain

2

Hello, I downloaded and extracted the toolchain version `gcc-rv32imc-20210412-1`, but I weren't able to install it. What did I do wrong here? ``` aaron@aaron-TravelMate-P238-M:~/Downloads$ cd /home/aaron/Downloads/lowrisc-toolchain-gcc-rv32imc-20210412-1 aaron@aaron-TravelMate-P238-M:~/Downloads/lowrisc-toolchain-gcc-rv32imc-20210412-1$ sudo ./configure --prefix=/home/aaron/new1/...

Hello! Nice work on your project and i'm interested in recreating your work for a student club! I'm new to FPGA and currently using a Xilinx Artix-7 FPGA (Nexys 4...

Issue with Vtop_verilator when running simulator. ; Replaced with Vibex_demo_system

1

Hello, so as i was going through the procedures, i was trying to run the simulator by running `./build/lowrisc_ibex_demo_system_0/sim-verilator/Vtop_verilator \ --meminit=ram,./sw/c/build/demo/hello_world/demo `, as stated. However, for some reason it produced...

Simultaneously writing and sending data from multiple channels

1

Hi! First of all, nice work on this! I am a student trying to use the GUI to simultaneously sending and reading and plotting the graphs. But It seems that...

May I know if this gemm design able to be used to export to vivado design flow instead of vitis kernel? Thank you.