Odin
Odin
Hey ridingg, AFAIK you need to choose ABS_SS instead of ABS_S to run with the uPrint. regards 256FF aka akb ;-)
And voila, after decrypting your 4% dump: 
I "know" two ways to change the tip-temp: 1. maracaEx  2. System file I don't know where exactly
This Code means: "Abort : Head temperature setpoint too low." Verify the head temperature set point using CatalystEX • The model must be above 240 degrees. • The support must...
If you use the newest code you must use P400SR instead of ABS_SS.
Hi ridingg, sorry, I don't know an option to change the extrusion rate. But you can try to decrease the distance in insight, also negative values are possible. Try start...
Does it warp? You can try to increase the base oversize oder base hight to avoid the warping.  
ah, ok. Did you try to use a glue stick to prepare the base plate? Maybe this can help.
Do you have send me an PM in 3dprintforums.com? If yes, you alreade have it :-)
uprint is a bit special. You are definitly unable to write to this chip. It is possible to decrypt the data with bvanheus script but I have not had success...