change line width from 1 to 0.05 for Edge.Cuts svg

Open un01s opened this issue 2 years ago • 3 comments

the change is simple. but I am not sure if the line width of 1 is intended for other purpose. please review. it is ok if I am wrong.

Dec 27 '23 20:12 un01s

This is intentional since in older versions of KiCAD it prevented copper from being too close to the edge. Is 0.05 the default value in KiCAD these days?

Dec 27 '23 21:12 theacodes

I did not know this trick. Thank you. So my Edge.Cuts has the width of 0.05. Usually I rely on the margin layer to get it done. For example to draw a line along the edge to prevent the pours leaked. I guess you could close this PR without merging.

Dec 28 '23 17:12 un01s

No, we can still merge! I just wanna make sure we're using the default kicad value. :)

Dec 28 '23 20:12 theacodes