NetEraser

A tool that deauthenticates 2.4GHz and 5GHz Wi-Fi networks using BW16.

Key Features

• Minimal Setup.
• Simple Interface.
• It deauthenticates 2.4GHz and 5GHz WiFi networks both.

Hardware Requirements

• Ai-Thinker BW16 RTL8720DN Development Board

Note

• It has two variants : Type-B and Type-C connectors.

Setup

1. Download Arduino IDE from here according to your Operating System.

2. Install it.

3. Go to File → Preferences → Additional Boards Manager URLs.

4. Paste the following link :

   https://github.com/ambiot/ambd_arduino/raw/master/Arduino_package/package_realtek_amebad_index.json
   

5. Click on OK.

6. Go to Tools → Board → Board Manager.

7. Wait for sometimes and search Realtek Ameba Boards (32-Bits ARM Cortex-M33@200MHz) by Realtek.

8. Simply install version 3.1.7.

9. Restart the Arduino IDE by closing and open again.

10. Done!

Install

1. Download or Clone the Repository.
2. Open the folder and just double click on NetEraser.ino file.
   • It opens in Arduino IDE.
3. Compile the code.
4. Select the correct board from the Tools → Board → AmebaD ARM (32-bits) Boards.
   • It is Ai-Thinker BW16 (RTL8720DN).
5. Select the correct port number of that board.
6. Go to Tools → Board → Auto Flash Mode and select Enable.
7. Upload the code.
   • Wait for sometime, the GREEN led turns ON.

Run the Script

1. After uploading wait 1-2 minutes and after that an Access Point is created named NetEraser whose password is neteraser.
2. Connect to it.
3. Open any browser and type the following IP : 192.168.4.1.
4. Select the network want to deauth by click on the radio button.
5. After that, click on Start button.
   • The Red led start flickering means it deauthenticates that network.

Note

• Sometimes, it can't deauth at starting.
• So go back to main page and click on Start button.

Indicators

• 🟢 - The BW16 board is ready to deauth.
• 🔴 - The BW16 board is sending deauthentication frames.