Stefan Kalscheuer

Could you share your wireless configs? I'm personally running an _r21989+2-5155200f97_ build (Kernel 5.15.91, wpad-openssl) on an _mvebu_ device with dual MT7915AN setup, both 2.4 and 5GHz radios in AX...

The update is not trivial in this case. Jetty 12 was split into submodules for Java/Jakarta EE 8, 9 and 10 with different Java packages which has potential for conflicts...

Just for the record, this _may_ cause interesting issues, if you actually use Jetty components in your application outside of Wiremock. If this is the case, carefully check your dependency...

Typically via USB from an OctoPrint server. SD only for firmware testing purposes. Running a custom fork of upstream Marlin 2.1.2 which has pretty much all changes from Knutwurst `MEGA_P_DGUS_BLT_10`...

Just one thing, that came to my mind: did you reload EEPROM defaults (from the special menu or with `M502`) once after flashing from stock FW to Marlin 2? No...

Was there any error message in the serial output when the printer stopped or did you maybe save the last log lines? I thought I had a suspicion, but on...

Thanks for testing again. Looks like the host is cancelling the job. Actually, it's not exactly the the first layer, there is one move missing, before fan speed goes up...

Well, Marlin 2 should support relative positioning, I'm not aware of anything that prevents you from using it. To be honest I never cared about it, but my previous GCode...

OK, missed that one :+1: Still interesting, but good to know that there's a simple solution. I'll try to do a relative job next time I use my printer with...

Good point.