rstrouse
Wifi fallback does not work at first boot
Hardware
ESP32 WT32-ETH01
Firmware version
v2.4.6
Application version
v2.4.6
What happened? What did you expect to happen?
Hi Robert, My board is configured : -Use Ethernet -Fallback to Wireless Working OK with ETH, Working OK with Wifi ETH -> Wifi : Fallback is working OK But if you start the board with ETH disconnected, it will never connect to Wifi
How to reproduce it (step by step)
1- Start board with ETH disconnected -> it never fallback to wifi
Logs
No response
Interesting. Did you wait at least 30 seconds for the wired delay to kick in. In this initial condition users have asked that there be a delay prior to attempting to start the wireless connection to allow for managed switches and the like to come online during a power loss.
Either way I will set up this scenario and try it out.
I tried this out and it is waiting for the adapter to respond. I will look at modifying the timeout to fallback when there was not a wired connection to begin with.
v2.4.7 - Pre works around not getting a disconnected output from the wired connection if it has never been established. Interestingly this is not the case for a wireless device. It always reports a disconnect if the connection failed. Either way if nothing can be established it will stop the connection attempt after 20 seconds. Install the v2.4.7 pre-release and let me know if it fixes your issue.