Erase at 0x000000... Error 1

[JostBrand]

Hi its me again. Thanks for directing me to this step. I’ve successfully connected the SWS Pin to the second pin from the top right corner on my TB-04-Kit. Upon comparing the TB-03F-Kit and TB-04-Kit, it appears that the CH340C is not only identical but also similarly aligned. When I executed the command you provided, the following output was produced:

Error Write Flash data at 0x000c00!
❯ python TlsrComProg.py -p /dev/ttyUSB0 -t5000 we 0 ../uart2swire.bin                                             ================================================
TLSR825x Floader version 27.12.23
------------------------------------------------
Open /dev/ttyUSB0, 230400 baud...
Reset module (RTS low)...
Activate (5000 ms)...
Warning: Wrong RX-TX connection?
Connection...
Load <floader.bin> to 0x40000...
Bin bytes writen: 1960
CPU go Start...
------------------------------------------------
ChipID: 0x5562 (TLSR8253), Floader ver: 1.1
Flash JEDEC ID: c86013, Size: 512 kbytes
------------------------------------------------
Inputfile: ../uart2swire.bin
Write Flash data 0x00000000 to 0x00000dfc...
Write to 0x0c00... Error 1
------------------------------------------------
(1) Warning

Note that I am on Linux. Can this be related to the OS? I saw your comment in the other issue.

[pvvx]

 _   _ ____  _   ____  _
| \ | |  _ \(_) |  _ \/ |
|  \| | |_) | | | |_) | |
| |\  |  __/| | |  _ <| |
|_| \_|_|   |_| |_| \_\_|

Welcome to Armbian 22.11.4 Bullseye with Linux 5.15.89-sunxi

System load:   2%               Up time:       28 min
Memory usage:  8% of 999M       IP:            192.168.2.37
CPU temp:      29°C             Usage of /:    31% of 7.0G
RX today:      0 B

[ General system configuration (beta): armbian-config ]

Last login: Thu Mar 14 03:11:23 2024 from 192.168.2.4

root@nanopi-r1:~/test# python3 TlsrComProg.py -p /dev/ttyUSB0 we 0 TLSR825xScaner.bin
================================================
TLSR825x Floader version 27.12.23
------------------------------------------------
Open /dev/ttyUSB0, 230400 baud...
Reset module (RTS low)...
Activate (600 ms)...
Warning: Wrong RX-TX connection?
Connection...
Load <floader.bin> to 0x40000...
Bin bytes writen: 1960
CPU go Start...
------------------------------------------------
ChipID: 0x5562 (TLSR8253), Floader ver: 1.1
Flash JEDEC ID: c86013, Size: 512 kbytes
------------------------------------------------
Inputfile: TLSR825xScaner.bin
Write Flash data 0x00000000 to 0x0000e024...
------------------------------------------------
(1) Warning

I usually connect it manually while the bootloader is starting. Once the bootloader is loaded, no connection is required. But the connection can be left for the entire programming time...