PortalGun
PortalGun copied to clipboard
pomeroyb
Code to control a Portal Gun (From Rick and Morty)
PortalGun
Code to control a Portal Gun (From Rick and Morty)
##Libraries Download and install the following libraries:
Pin Definitions
If you deviate from the following definitions, you will have to change the firmware to account for that.
| LED Display | Trinket Pro Pin |
|---|---|
| SCL | A5 |
| SDA | A4 |
| GND | GND |
| Vcc | 5V |
| Vi2c | 5V |
| Rotary Encoder | Trinket Pro Pin |
|---|---|
| A | A1 |
| B | A0 |
| GND | GND |
| Button | A2 |
| LED | Trinket Pro Pin |
|---|---|
| Top Bulb | 9 |
| Front Right | 3 |
| Front Center | 5 |
| Front Left | 6 |
Installing Firmware
First, set up the Arduino IDE according to Adafruit. Connect your Trinket Pro and make sure the bootloader is running, then click upload.
Button Behavior
The rotary encoder has a click button, and we can detect a single click, a double click, and a hold.
- Single Click : Wakes the Trinket Pro from low power mode
- Double Click : Reset to dimension C137
- Hold : Turn off LEDs and put the Trinket Pro into a low power mode.
##Installing SFX The main branch doesn't have SFX support. Use the SFX branch to test this out (I found that the speaker inside the case was too quiet to hear.)
pomeroyb