tobecontinue
需要先自己导入或者配置
I use spring-boot 2.5.0 and don't meet this issue, the code just works fine. can you show your designController?
yes, invalid params don't indication where is wrong
I seem to run into the same issue in 23.1.3 version ``` | INFO | QbftBesuControllerBuilder | Produced #89 / 0 tx / 2 pending / 0 (0.0%) gas /...
@CaixiangFan hi you met any issues benchmarking with caliper? I always ran into nonce too high problem even sending not too high tps
> > > > Hi no I didn't have this problem. Nonce too high might be caused by the previous txs not being processed. You can refer to my benchmarking...
> > > > No; I didn't run into these issues. If the Caliper couldn't generate more than 100TPS, it should be a config problem on the Caliper side. Not...
> > > > Yes, otherwise you will get the nonce issue. did you modify caliper or use many worker processes?
hi @bluele this project may not be for ethereum PoW/PoS blockhains, right? as it doesn't implement the light clients