firmware icon indicating copy to clipboard operation
firmware copied to clipboard
verified publisher icon meshtastic

[Bug]: Not reading the log buffer causes node to stop working

Open andrewheadricke opened this issue 7 months ago • 0 comments

Category

Other

Hardware

Rak4631

Is this bug report about any UI component firmware like InkHUD or Meshtatic UI (MUI)?

  • [ ] Meshtastic UI aka MUI colorTFT
  • [ ] InkHUD ePaper
  • [ ] OLED slide UI on any display

Firmware Version

2.6.10

Description

I recently upgraded to 2.6.10 firmware from 2.6.4 and i've noticed when I stop reading from the device (either BLE or Serial) the device eventually locks up and stops functioning. However when I reconnect and drain the buffer it appears to start functioning again.

This means a standalone node without anyone actively connected to it will stop functioning, and if you have a lot of radio traffic that buffer appears to fill in a matter of minutes.

Relevant log output

andrewheadricke avatar Jun 18 '25 01:06 andrewheadricke