meistertek

I believe the stock LCD on your replicator dual probably sends g-codes to the Mightyboard. Are you asking if a MKS TFT 28 or similar could replace the stock LCD...

Most people ditch their mightyboard and go with a MKS Base or SBase motherboard. If I were you, I'd simply try wiring up the MKS TFT 28 and seeing if...

I was confused by a blank MKS TS35-R V2.x screen issue as well after updating my MKS DLC32 V2.x control board with the latest firmware [V2.1.0_H35_20220526_02_N_CNC.bin](https://github.com/makerbase-mks/MKS-DLC32/blob/main/MKS-DLC32-main/firmware/TS35/CNC/Normal/Board_v2.0/V2.1.0_H35_20220526_02_N_CNC.bin). As @WRFleming57 says above...

Thanks @JBKingdon , I'll work on building a handset and while doing that I'll take a look at the existing C/C++ code. I'll then look at the V3 over-the-air format...

> I'm afraid the current software doesn't support elrs V3 or even V2. It would be possible to bring it up to date, but it's a fair bit of work...

Has this issue been replicated at LDO with testing? I would think that a firmware update would address this issue, or does it require a hardware revision? Has this issue...

> Hi, I'm now on 6 hours attempting to get this board to do anything. I initially started with the WiFi set-up, it appeared to work but nothing showed up...