status of v0.0.2

Open rlourette opened this issue 5 years ago • 1 comments

Just curious if there is a planned release of v0.0.2.

Nicely documented project BTW. I am hoping to build it.

Rich

Jun 30 '20 19:06 rlourette

Hi,

I have not actually put much effort into eFlow in a while. It works great as is and I've been using it.

If you're considering building it, the two areas of improvement would be:

1 - Improve the UI for solder paste selection. What's there works now but could be better. 2 - Switch from using thermocouples to use an RTD temperature sensor. An RTD would be cheaper, easier to source parts and it would be better suited for the temperature range of the oven.

Otherwise, it does work great. Ping me if you have any other questions.

Jun 30 '20 19:06 mc-hamster