Bed_Distance_sensor
Bed_Distance_sensor copied to clipboard
markniu
Auto bed level with High resolution distance sensor
This is my probe: BDsensorVer:V1.1 pandapi3d.com ,switch_mode=0,collision_homing=0,collision_cal=0 It is connected to the BL Touch port on a BTT Manta M5P [BDsensor] sda_pin: PC13 scl_pin: PC15 delay: 20 x_offset: -33 y_offset:...
My setup was broken. So i had to reinstall everything. I am having an issue with katapult not being able to access after flashing the ebb42. So I have to...
Hello Mark, hope you are fine. It si not one issue, but I would like to ask you if you can update your documentation by adding all the necessary steps...
Keep getting this error after updating to the latest klipper. If i disable the bed distance sensor klipper works fine. It needs an update firmware for the bed distance sensor...
When performing an uninstall, the change to `scripts/buildcommands.py`made during installation... ``` sed 's/--dirty//g' "${HOME_DIR}/scripts/buildcommands.py" -i ``` ... isn't reverted
I was wondering if there would also be a Raspberry Pi test project in the future like there is for the Arduino. I think the sensor has some potential for...
Beacon has a metal "keep out" area in their mounting instructions. Does BD_Sensor have similar considerations? The mount I am designing has a screw directly centered above the coil and...
Hi mark, it would be useful to have the activation code like TAP for homing with collision at 150° C in bd sensor config and prevent error with temperature can...
I successfuly instaled the bdsensor. I am using klipper. none of the calibration attemps gives successfuly result. ı was happy with bltouch, ı assume this sensor will be better. the...
Hi every time I use the M102 S-1 or M119 Command klipper shuts down I'm using a CR10S Pro V2 swapping from a BLtouch [klippy (2).log](https://github.com/markniu/Bed_Distance_sensor/files/13729273/klippy.2.log)
