firmware

firmware copied to clipboard

We are using firmware version 15.7 on a custom NXP imx8mn module. wilc1000 is connected via SDIO. Kernel is `lf-5.15.71-2.2.0` from NXP, based on mainline `5.15.71`. The first start of...

ghost

WILC1000 Kernel Panic

5

The following kernel panic was observed while shutting down Linux. This kernel panic occurs intermittently. Running v15.5 of the WILC1000 firmware/kernel driver. [ 190.921835] Unable to handle kernel NULL pointer...

mmader87

ISSUE: Failed to initialize wilc (linux4sam-2021.04)

2

Hello, I am facing an issue with the WILC3000 firmware 15.5 directly from the kernel 5.10.50. I have my SAMA5d27-som1 and my WILC3000 fully working with the version (linux4sam-6.0 WILC...

davidtekin37

4 addr mode is required to allow WLAN0 and P2P0 interfaces to be bridged. Currently this is not supported, and when logged via salesforce, there was no traction to get...

tsifb

This was "resolved" in an previous release, but the problem is still there: ``` 3: wlan0: mtu 1500 qdisc pfifo_fast qlen 1000 link/ether fa:f0:05:da:2e:02 brd ff:ff:ff:ff:ff:ff inet6 fe80::f8f0:5ff:feda:2e02/64 scope link...

n3b0j5a

Suboptimal uplink performance with weaker signal links

22

This issue is to note an observation seen while testing another issue, and possibly highlights that there is an issue (or at the least, an optimization opportunity) with the WILC1000...

tsifb

NOTE: Reported in Salesforce. Ticket number 00535866 (now at 2 weeks waiting for Microchip WILC team response.) When sending packets between 2 WILC devices (AP+STA), the rx'ed packet ethertype field...

tsifb

Hello, I am currently working on porting an application to the "SAMA5D27 WLSOM1 Evaluation Kit" that uses the ATWILC3000 chipset. I'm using: Kernel: linux4sam-2020.04 i.e., kernel 5.4 WILC Firmware: 15.4...

christiansanden

send_ntwrk_info: Failed to alloc memory for beacon/probe rsp

3

Hardware: SAMA5D4Xplained dev board + ATWILC1000-SD (rev 4) dev board Software: wilc_demo 15.2RC1 from: https://github.com/linux4wilc/wilc_demo/tree/009b36048d18ffb64b2140eeecd0194cc21cbfd4 Updated firmware to 15.2RC3 firmware for this one: ``` # cat /etc/wpa_supplicant.conf ctrl_interface=/run/wpa_supplicant ctrl_interface_group=0 network={...

HDC67

BLE version support

3

Hi, I am searching for you documentation which version of BLE is supported by you BLE module. While searching I just got confused that sometime the specification is mentioning BLE...

sleeping-barber