Brain

Brain copied to clipboard

hi , i wanted to know if i can use the power band frequency as an output , i used brain.readDelta .. .. and so on but still i have...

Revix1998

Nothing on Serial

20

I wired up everything correctly: the tx pin of my starwars force trainer II headset and the rx pin of my arduino uno. But the BrainSerialTest example does not write...

ghost

Question about the Frequency

4

hello, im trying to do a project where i can read the Delta, alpha, beta ... ect. my probelm is that i dont know how to pull the frequency as...

Revix1998

signal strength

52

I've got the mindflex 2 wired to arduino uno , but the signal strength never reached the zero and always the attention and meditation values are zeros, that's when i...

cslinux

Reading Serial Data Manually

62

I couldn't figure out how to make this library work and was wondering how I could parse serial data manually. I am getting data but I don't know what it...

nikhilanayak

Whenever I run the Serial Test I get Error 703. I don't know what these errors mean. Any help would be appreciated.

nikhilanayak

Adding opto-isolater to mindflex

2

Hi all, I have a mindflex headset which I have set up according to this tutorial(http://www.frontiernerds.com/brain-hack) however the signal strength never reaches 0 and as such I cannot get the...

r-bt

Raw values

31

Hi! Has any work already been done regarding raw EEG values from the ThinkGear module? Switching the mode works, so I do get values that look like ThinkGear packets at...

steeph-k

ERROR:PACKET TOO LONG

12

I get this error after running the serial monitor for a few minutes every time.

ghost

Checksum error

2

I have hacked my Mattel MindFlex using these instructions: http://frontiernerds.com/brain-hack I'm printing the readCSV and readErrors: 80,0,0,181761,359220,55384,11126,48659,361307,168113,37803 ERROR: Checksum I always get 0 for both readSignalQuality and readAttention. Any help...

LeonNicholls