Marlin
Marlin copied to clipboard
kad
Customized fork of Marlin Firmware, specifically for Anycubic Mega Zero printers. Check Wiki for more details and instructions.
hi, I instal a BLtouch and a runout sensor on my MZ V1 and upload the firmware with the BL option but how can I enable it on the printer...
i flashed the "amz2_melzi_bl_a2-2.0.9.3-kad1-firmware" to my stock MZ2 with added BLTouch clone. After sarting it up and doing Auto-Home it will work fine. however if i go and move the...
Hi, I flashed the latest prebuilt binary on my SKR MINI E3V3. Works well, but I had the issue of annoying PWM noise anywhere between 1-99% fan speed. I tried...
Good morning, I have looked but cannot find answers. My MZ2 with minie3v3 works except for the Z axis not stopping even if I activate the bltouch by hand and...
Hi Thanks for the great work in this repo. I need a little help to install a BTT EEPROM extension module to my BIGTREETECH SKR E3 Turbo board: https://github.com/bigtreetech/BIGTREETECH-SKR-E3-Turbo https://github.com/bigtreetech/BTT-Expansion-module...
hi , i need help to built a variant for the amz_skr _mini _mz with these fonction bed_bl_sfs and i don't know if i have the btt_mini or the btt_mini_maple....
Hi I am using the latest code from anycubic-kad-bugfix-2.0.x to compile the firmware for target anycubic_mega_zero2_btt_e3turbo_bl_e0fan. Without doing any changes to the Marlin code, I am getting this error when...
Hello. First of all congratulations for your great work with this printer. I have obtained very good results, and it is a luxury to have information like this at our...
When using the corner leveling procedure, the nozzle is actually set to z=0 (the default for LEVEL_CORNERS_HEIGHT). So when leveling, this means that actually I should put nothing between the...
Hello All For some reason whatsoever my PSU makes strange click noises: https://photos.app.goo.gl/tWFLZF5hVtahtbde6 I goes hand in hand with the light on the mainboard that blinks whenever the temperature for...