ebusd

ebusd copied to clipboard

Arbitration lost

11

### Description In every try to load configuration it end with arbitration lost error message. It starts on version 22.1. I have Vaillant VR470F + VR61 ### Actual behavior [main...

Koky05

include in local config-files doesn't work

5

### Description the include (and load) directive in local config files doesn't work. I start ebusd with: "ebusd --checkconfig -c /home/pi/ebusd-conf/test --loglevel=debug" Files in /home/pi/ebusd-conf/test: 15.700.csv _templates.csv errors.inc Directive in...

guenni1956

ebusd | no switch on mixer cycle | wolf CGB-2 (AM), BM2 wall mounted, DWTM

9

Hi, I've sent a support request to fhem, I got no answer yet https://forum.fhem.de/index.php?topic=123866.0 maybe here: my heating system as follows CGB-2 (AM), BM2 wall mounted, DWTM as mixer configuration:...

eh-gh

Update check issue

2

### Description The official binary build reports the following version number: ``` ebusd --version ebusd 22.3.p20220508 ``` It looks like the update check expects the revision to be equal to...

kratz00

Connection to ebus adapter lost until adapter or ebusd is restarted

43

Hi, I have finally managed to configure WiFi ebus adapter with my Vaillant ecoTEC and home assistant using MQTT. In home assistant I register like 10 Vaillant variables to be...

mbisak

ESERA eBus ethernet receive format problems

9

Hi, I am currently trying to get the setup ebusd ESERA eBus ethernet adapter vaillant ecotec plus (ebus connector) work and could not find any better place to ask (maybe...

HSE83

Bus signal lost and re-acquired but polling does not restart

2

### Description I have ebusd running on a Raspberry Pi connected to an adapter 3 with WiFi. It has been running mostly smooth for the last couple of month, but...

jannis-h

Set ebusd values on MQTT with payload in JSON format

23

### Description I use ebusd's MQTT output in JSON format, so I get the following result when querying the heating time slots: To set these values I have to use...

estegewr

WOLF BM-2: strategy to find a specific read command

7

In my system the BM-2 controller is a slave at address `35`. At the moment I only know 2 of the read commands: `CC7427` - heating mode `CC7527` - dhw...

bdariusb

ebusd don't work with Vaillant auroMATIC 620

11

Hello, I need help for ebusd wirth Vaillant auroMATIC 620. I get only the outsidetemp with ebusd + iobroker and can not find the failure. Many houres I've read in...

baggerfahrer441