ebusd-esp icon indicating copy to clipboard operation
ebusd-esp copied to clipboard
verified publisher icon john30

ESP32 HW-665 image

Open nyxnyx opened this issue 3 years ago • 3 comments

Hi, I've installed image (factory one since it was first install of image) for ESP32 but it didn't run. My chip is probably a clone of WROOM-32: Chip id is ESP32D0WDQ6 (revision 1) Flash size is 4MB

can someone help?

nyxnyx avatar Dec 07 '22 18:12 nyxnyx

Hi, same issue with chip id ESP32-D0WD-V3

Filippo125 avatar Dec 30 '22 18:12 Filippo125

Hi, I am having the same issue trying to flash 20221215 on an "ESP32-D0WD-V3 (revision 3)" on a D1 clone board, using NodeMCU PyFlasher. The serial port repeats:

rst:0x10 (RTCWDT_RTC_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:QIO, clock div:2 load:0x3fff0030,len:1184 load:0x000002c6,len:738469239 ets Jul 29 2019 12:21:46

Flashing ESPEasy works just fine.

CherAlban avatar Jul 21 '23 16:07 CherAlban

the chip is not the only thing that matters. also the IO association might be different or just not working. so, no other than the variants mentioned in the readme are supported

john30 avatar Aug 15 '23 11:08 john30