Joseph C. Lehner

> If you live in Europe, you can often find cga4233de on https://www.ebay-kleinanzeigen.de/ for less than 20eur(I think I got mine for 10eur). @madushan1000 I've finally found someone who was...

Hmm... I've hit the first obstacle unfortunately. The SPI flash on my device uses a TFBGA package, not the SOP I was expecting (and hoping for), so I can't just...

> @jclehner If they are bga both NAND & SPI, I could say where the through holes are located to simply scratch the pcb and you can solder but I...

> @jclehner I opened the modem and I see that it has tracks directly to the cpu without through holes, I leave you photos the only way that I see...

> Well, if you have experience, it is not difficult, just use some enameled wire as thin as possible 0.1mm at least, there are 4 tracks wp, si, so, clk...

I've finally gotten around to working on this again a little bit. Didn't break the router this time, and I've now got SPI access to the flash. @arrobazo, while @madushan1000...

So I've been quiet on this topic the past months, but I've made some, albeit slow, progress. I've managed to trash the PCB tracks on my first CGA4233 before I...

> @jclehner were you able to get root credentials for RgLinux console? from eCos_cm (switch_console) Not yet. On the firmware I'm currently working on, the `switchCpuConsole` command seems to be...

I've been busy these past few months, but thanks to a very kind donation of a few non-DE CGA4233, I've now manged to get root access to the modem's Linux...

Hi! You're right, I'm getting the desired results with `-mips32 -mno-abicalls -mabi=eabi -msoft-float`! > I have a repo on my profile with with some of my RE stuff if you're...