bekantfirmware
bekantfirmware copied to clipboard
ivanwick
Programmable position memory for IKEA BEKANT adjustable sit/stand desk
At the end of the installation guide it is stated to plug the controller back into the legs. However it never says to unplug the table in the first place....
I have flashed the latest firmware and everything works as expected. But sometimes the controller does not react to the buttons. After unpluging the power cord, wait some time and...
Hello, I flashed my desktop with your firmware. Everything works but if the office down to the bottom, the relay remains active. Is there a low position memory on your...
Great project. Have ordered a flasher to try it. I like the logic you have set. A few more pictures of backing up and programming would be helpful for beginners....
Hi. I have tried to flash the controller today and I was able to flash the pic but not to be able to read. I did try to do a...
Hi, I would like to be able to get current position & control of the table for further processing. Think of e.g. - Automatic notifications that I have been sitting...
Just wanted to say "Thank you!". I just flashed your firmware on my new bekant desk and it is so much better now. Thanks for your work!
Since it is the hardest part of the whole installation it would be nice to have a reference to a dissasembly guide for the controller box in the installation walkthrough....
