Ryan Powell
Ryan Powell
The whitelist has a limit of 12 I believe. I would erase whitelist entries by comparing with the bonded device list and delete any addresses that are no longer bonded.
Yes there is a bond limit, defaults to 3, you can change it in the config.
Yes, that is by far the best way to go about this.
There is no limitation in the stack, what error messages are you seeing? Have you adjusted your connection parameters as suggested?, though in my experience I have never needed to...
Do you have bonding enabled? This can happen if the bond is deleted.
If you are needing to support GATT on your client device then you are operating in a peripheral role so it should not be disabled.
Thanks for pointing this out, I'm not sure yet why this occurs, it may be an upstream error and I will look into it, though it may be a controller...
Thank you @truefalsenone, this is quite the problem for sure. The crash appears to be caused by something that occurs after the connection fails, can you decode this and post...
Thank you for the information @Jeronimo59, at this time I have not found any reasonable solution to this, nor have I been able to reproduce it. If you can enable...
@Jeronimo59 It's an interesting thought, maybe the buffers are getting exhausted and preventing the disconnect event from being triggered. If instead you use the onStatus callback to send the notification...