EvilCrowRF_Custom_Firmware_CC1101_FlipperZero
EvilCrowRF_Custom_Firmware_CC1101_FlipperZero copied to clipboard
h-RAT
This firmware is an alternative to the EvilCrowRF default firmware. Module: CC1101 - Compatible Flipper Zero file.
Hello there, Just received my evilcrowrf2 from aliexpress(`Evilcrowrf-v2 Hack Two` written on the back). I tryied to install following the step, but I can not get any WIFI to connect...
Evilcrow RF V2, latest bin. Connected to my wifi router, scanning frequency's. After 2-4 minutes it just hangs, disconnects from my router, shows his own wifi AP and when I...
Hi, i have the EvilCrowV2 working with default firmware v1.3.3 Attempted to load this FlipperZero firmware. Copied the three folder CONFIG, HTML and SUBGHZ into the SD card. From firmware...
Hi! I just sent a Tesla EU signal on bruteforce menu and found out this: 1. I set a Bruce T-embed cc1101 on scan/copy RAW 2. Send the Tesla signal...
someone got th same error? Using 'COM3' as serial port. Unexpected error: could not open port 'COM3': PermissionError(13, 'Acesso negado.', None, 5)
Hi, thank you for your great project. It's very accurate and well done. But I have a problem: I built it and it works fine, but after a while it...
