Expose all the pins

[LinoBarreca]

Hi. The idea is nice but it still has a fault: Suppose I want to pilot this through a microcontroller let's say a UNO. It would be VERY nice to connect it directly with ATX pins to trigger some actions. (ie: remote on by grounding the pin, power ready, remote voltages monitoring and so on) for the next board revision you should add a female connector for each of the atx pins (without any electronics of any sort)...an array...or a board hole in which one can solder it (male or female as needed) . in that connector you could put a jumper cable to connect it to arduino (or other electronics) to monitor/pilot the board and the PSU.

[LinoBarreca]

something like this, for example.