Ender 3 V2 Print Settings

[bigT77]

What happened

Hello, I am not sure if Fluidd supplies the default printer settings, but my setup is via Kiauh.

What did you expect to happen

I wasn't able to extrude until I reverted back to my older config file saved on my pc.

How to reproduce

Not working

[extruder] max_extrude_only_distance: 100.0 step_pin: PB4 dir_pin: PB3 enable_pin: !PC3 microsteps: 16 rotation_distance: 34.406 nozzle_diameter: 0.400 filament_diameter: 1.750 heater_pin: PA1 sensor_type: EPCOS 100K B57560G104F sensor_pin: PC5 control: pid tuned for stock hardware with 200 degree Celsius target pid_Kp: 21.527 pid_Ki: 1.063 pid_Kd: 108.982 min_temp: 0 max_temp: 250

I reverted back to the original file I had saved on my pc. Below is the working config.

[extruder] max_extrude_only_distance: 100.0 step_pin: PB4 dir_pin: PB3 enable_pin: !PC3 microsteps: 16 full_steps_per_rotation: 200 gear_ratio: 50:17 rotation_distance: 23.132 nozzle_diameter: 0.400 filament_diameter: 1.750 heater_pin: PA1 sensor_type: EPCOS 100K B57560G104F sensor_pin: PC5 control: pid tuned for stock hardware with 200 degree Celsius target pid_Kp: 21.527 pid_Ki: 1.063 pid_Kd: 108.982 min_temp: 0 max_temp: 250

Additional information

No response