Transaction not appearing on ledger for signing

[lukeellison]

Hi,

I'm having a bit of trouble getting my transaction to sign with my ledger hardware wallet. It simply says the application is ready on the screen but in Frame is shows the attached image. This happens every time I have tried repeating it.

Any recommendations would be appreciated.

Thanks!

[goosewobbler]

Hi @lukeellison, have you tried removing the relevant ledger address from the signer panel and then adding it back?

[saltyfacu]

Hi @lukeellison, have you tried removing the relevant ledger address from the signer panel and then adding it back?

I've been using frame the last 2 weeks and this happened quite a lot. The tx doesn't show on the Ledger, I have to disconnect it, connect it again, cancel the tx and send it again. It's quite inconvenient that Frame is not retrying constantly.

It would be useful, also, to have the hw wallet status shown. It already shows if there's a signer selected, same thing but for the hw wallet

[goosewobbler]

@saltyfacu @lukeellison We're planning to rework our signer interface after the omnichain release, which should address these issues.