estarz

Redundant and incomplete (can something be both...) comment regarding MetroCluster IP

1

### Page URL https://docs.netapp.com/us-en/ontap/upgrade/concept_upgrade_paths.html ### Page title Supported ONTAP upgrade paths ### Summary Section "From ONTAP 9.8" has 2 similar lines regarding MetroCluster on certain platforms. If you are upgrading...

Typo on page

2

### Page URL https://docs.netapp.com/us-en/ontap/ontap-security-hardening/tls-ssl.html ### Page title FIPS mode and TLS and SSL management ### Summary "Either **TLSv.1** or TLSv1.3 will remain enabled depending on the previous configuration." TLSv.1 should...

### Page URL https://docs.netapp.com/us-en/ontap/ontap-security-hardening/tls-ssl.html ### Page title FIPS mode and TLS and SSL management ### Summary Reading through this page, it would seem TLSv1 and TLSv1.1 were enabled per default...

Clarification needed on default accounts vs built-in accounts

3

### Page URL https://docs.netapp.com/us-en/ontap/ontap-security-hardening/default-admin-accounts.html ### Page title Default administrative accounts ### Summary Never understood there is a difference between built-in accounts and default accounts but apparently there is. I've always...

### Page URL https://docs.netapp.com/us-en/netapp-solutions/hyperv/hyperv-smas.html ### Page title SnapMirror Active Sync with Microsoft Stretch Clusters ### Summary In the Introduction section: Should be "stretched, right? Thanks, Erik ### Public issues must...

### Page URL https://docs.netapp.com/us-en/netapp-solutions/hyperv/hyperv-smas.html ### Page title SnapMirror Active Sync with Microsoft Stretch Clusters ### Summary Hi, In the Test Scenarios, the "vol offline" test fails and leaves the LUN...

Unclear how looking at CPU average helps understanding LDAP usage?

1

### Page URL https://docs.netapp.com/us-en/ontap/nfs-admin/display-ldap-statistics-task.html ### Page title Display LDAP statistics for ONTAP NFS SVMs ### Summary I am a bit puzzled by this page in the docs. Was looking for...