msrc
msrc copied to clipboard
dgatf
Multi Sensor for RC with RP2040 - FrSky D, SmartPort, XBUS, SRXL, IBUS, SBUS, Multiplex Sensor Bus, Jeti Ex Bus, Hitec
Hi, I'm using an Arduino UNO board for doing some tests with the project. Communication is Smartport and Hobbywing 4. I have the telemetry connection but all the values are...
Im getting Telemetry, the values looked saturated, but tried throttle and it is unresponsive now. I enabled feature "Live Link Enable" on the other page of Castle Link 3.85.00. It...
Hello Daniel, I try to build my own telemetry with an Teensy 3.2 board. My S-Port use the pin 1 (TX1). I try the Debug feature without success: #define DEBUG...
### now: - msrc samples the sensors' data and applies calcAverage() before values get stored for later transmission. averaged values hide interesting short term spikes, the sampling rate is of...
Hello, Is it possible to add CRSF telemetry for use with ExpressLRS and TBS devices ? Thanks, Pierre
Great Project, but as a JR Propo Pilot i'd also like to use this thing. So please add Support for JR DMSS Telemetry! Don't know where the Protocol is described,...
Any chance to get FPort2 protocol supported ? That being bidirectional would allow to use a single board both for telemetry and ppm demux (obviously with limitations related to available...
The Jumper R8 is an affordable ACCST receiver that supports telemetry. It does however use PixHawk protocol for telemetry so there's no way to hook up an msrc board to...
Hi pin used for Sensor SCL (GPIO 9) has incorrect label should be: **I2C0 SCL** currently the pin is labeled as: I2C1 SCL it may be confusing. image url: https://github.com/dgatf/msrc/blob/master/images/rp2040_zero_pinout.jpg
