Cannot choose interface

[jensome101]

When provided with more then one interface wifte shows a dialog to choose the one to use for monitoring. However in the latest version provided by Kali (which is also the lasted develepment version if I am not mistaken) selecting one of the interfaces results in the dialog to reappear.

After selecting one of the interfaces it says

enabling monitor mode on phy0... done

or (when the second interface is selected)

enabling monitor mode on phy1... done

Then the interface dialog reappears.

Maybe this is an issue with my specific hardware, but I unfortunately do not have the hardware to test that theory

Note: When starting wifite with -i interface the application works as expected

[MisterBianco]

Phy0 and phy1 are hardware address usually reserved for the system what wireless cards are you using? I suspect you don't have a valid card.

[k3n77]

same problem with jensome101, using TL-WN722N, can start with -i wlan1

[Sc0rp11]

Start the interface by airmon-ng start wlan1

[WilsonBradley]

Thanks.. that did the trick. Im using Raspberry Pi 3 on board wifi as AP and external USB RTL8187