David Elias
then, purchase an [ElectroDragon active board](https://youtu.be/sBRi85QoGuY)... a very good option and be free from wiring again..
Ok, the log attached, is from the RPi 5, running UGS 2.1.8 Also, the gcode, but NO MATTER what gcode is, it happens; not with the 2.0.13 Platform, it does...
> You need to attach files through github, email attachments does not work. Ok, here they are zipped [rewinderuniversalgcodesenderrasbperrypivisualizer.zip](https://github.com/user-attachments/files/16875479/rewinderuniversalgcodesenderrasbperrypivisualizer.zip)
> The log contains why this problem occurs. > > Can you right click in the console and choose "Enable verbose logging" and let it spew a couple of lines...
>  I'm hoping for some pointers about where to start troubleshooting. > > **Update: Solved. the E address line was on Pin 8 after all - I was...
Can You share a picture of your connections? E_pin present? Thanks in advance
Greetings, [Here, in this link](https://www.electronicshub.org/getting-started-with-stm32f103c8t6-blue-pill/), a complete guide, FIRST OF ALL, view, and be careful with the pinouts for voltage (GND AND +5V), then, use an USB TO UART to...
Greetings, Have You tried --led-multiplexing = 0 .. to.. 18 (panel types)?
Greetings, Can You all share a close picture of your HUB75 connector? -INPUT-
Greetings, And, what is your command? Your power supply? How much Amps gives? ONE MORE, Maybe you're swap the wiring HUB75 pinout, maybe...