SoftFever
SoftFever
Thanks. Can you take a look at these conflicts?
@tlhintoq Hmmm it should be supported already. Can you try this variable name instead? 'total_cost' Let me know if it works
> @SoftFever I've implemented the enum. I've set it to apply gap fill everywhere as the default option, which is consistent with current slicer behaviour. I've also added the option...
> @Ocraftyone and @SoftFever, I noticed your check builds were failing. I ran into the same issue here today and found that it's because the site hosting Boost (https://boostorg.jfrog.io/artifactory/main/release/1.78.0/source/boost_1_78_0.tar.gz) was...
> Just curious, why did we not use GitHub in the first place? Seems to be a very reliable source and more well known. Because Boost doesn't use github and...
> I guess it doesn't matter because the link is back up! 🎉 lmao, just 1 hour after I changed to github cache
> @SoftFever I believe we are good to go on the features. I have tested a bit in windows and I am about to do some testing in ubuntu. @Noisyfox...
> Just to complete here: #3099 Damn, how did I overlooked that
@jeremytodd1 Thanks, this is good feature. Any change you have model that can demonstrate this situation for me to test?
Thank you, everyone! The discussions have been very informative. In my opinion, both PrusaSlicer and SuperSlicer's approaches are effective. However, based on what I've seen, PrusaSlicer's "Extend sparse infill" feature...