Rem0o
Fan Control not working on all but 1 fan
Fan Control doesnt work on any of my fans but 1, which doesnt make sense, since its the same fans as the others
It might depend how those fans are configured in your BIOS, like if they are set to PWM vs DC and so on.
I tried switch to DC and PWM and both have the same problem still, I can only control 1 fan, do you think its a problem with the sensor or something? because Fan Control things they are at 0RPM when I can see they are spinning
I'm having the same issue. My case fans are all connected to one header on the MoBo. All fans (CPU and case) are DC and are set as so in the BIOS (with smart or constant voltage control). Inside FanCotrol those "System Fan 5" canse fans, as labeled by the software, can't be controlled. The BIOS labels this header is #4. Maybe because of the pump header (witch is in use)? My motherboard is a MSI MPG B550 GAMING PLUS. Thank you for the software! : )
@brunoosti
if your fans are all connected to 1 header, then you will only have 1 "control" card that actually does something. It's 1 control per header, not per fan.
Yes, of course, that makes complete sense. But the system fan 5 card does not change any of the 4 case fans speed even if I set the slider to 100%. I expected, as you explained, all fans would run full speed. CPU and VGA fans controls work as expected.
I've disabled "smart" fan speed in bios with no success. Could this be because of the fans being DC instead PWM? Though the MoBo controls them just fine using DC smart fan mode. Eventually will try connecting to a different header. Thanks for the help!
What I've tested: Only one fan connected to sys_fan4. Different header (sys_fan3) for all four case fans.
No success... : (. My water cooler CPU fans are PWM and case fans DC. Could the MoBo working with both interfere in how the software is able to adjust each header speed? Bios cand control both and monitors RPM just fine, as I've said before.