OpenGarage-Firmware
OpenGarage-Firmware copied to clipboard
OpenGarage
OpenGarage: open-source WiFi-enabled garage door opener
Make the ultra sonic sensor optional. Use the enable/disable features of sn1 and sn2 to perform the old functions of sno. (except and and or)
I have set the opengarage sensor to ceiling mode and put it somewhere where it is not obstructed by the opened garage door and attached a magnet sensor to the...
I am using an MQTT broker called flespi. Authentication is handled using a 64 byte user name. Example: 2bypoemSP5tE9gf0O4jRu7nMQZMlVsSNtg3FjdnY8Fq6JvWnn35H0ghG4TPPbxrs More info: https://flespi.com/kb/tokens-access-keys-to-flespi-platform I am unable to use this username as...
Hi - I recently bought OpenGarage and just added a DHT22 to the sensor to G05 and confirmed that it is working via the web GUI. But I am not...
Running Firmware 1.1.2 When trying to connect to a mosquitto broker listening on a port other than 1883, the connection is not made. I see nothing logged in the mosquitto...
In following issue I was explained that your API Documenttion says the RSSI signal strength unit is dB and not dBm. I think that's a typo as the OpenGarage Web-UI...
Everything is working as it should but each time i turn off (power outage) and power on the device, the relay click 2 short time (+/- 500ms) and 1 long...
I have an older garage opener that requires two clicks within three seconds to open or close. Is there a way to support this?
Hello, I would liek to know if I can get the status of my break beam sensor in open-garage so I can know when my door is blocked . Thanks...
Been running into problems with the OpenGarage FW where it connects to a weak AP rather that a strong one on same SSID. This is causing issues with delayed Blynk...
Metadata
Owner
Metadata
OpenGarage: open-source WiFi-enabled garage door opener