OPM
Normalized pore pressure or stress in 3D view - air gap value unintentionally set to inf
The Air Gap value is sometimes unintentionally set to inf when calculating normalized stress or pore pressure in 3D view for geomechanical models without possibility to manually set it to zero (or other values). This results in zero values only for normalized data.
Happens when well paths without defined airgap are imported (and no point at sea level is created).
Note also that the air gap used in the calculation of normalized 3D stress data is given by well data air gap if this is available and it is not possible to manually set air gap to a use defined value (the well specific value is still used unless the well is deleted). The normalized 3D data should be updated automatically when the Air Gap value is being changed (by entering a value)